Search found 196 matches

by kaiba_seto2004
Mon Oct 08, 2018 9:26 am
Forum: General Discussion
Topic: Accuforce Pro V2, HPP PRX pedals, and GIMX
Replies: 14
Views: 1540

Re: Accuforce Pro V2, HPP PRX pedals, and GIMX

Did you install Logitech Gaming Software ?
by kaiba_seto2004
Sun Oct 07, 2018 10:27 pm
Forum: Support
Topic: GIMX with Arduino Micro
Replies: 12
Views: 2045

Re: GIMX with Arduino Micro

Well, I don't think you can replace usb uart with arduino.
by kaiba_seto2004
Sun Oct 07, 2018 10:24 pm
Forum: General Discussion
Topic: Accuforce Pro V2, HPP PRX pedals, and GIMX
Replies: 14
Views: 1540

Re: Accuforce Pro V2, HPP PRX pedals, and GIMX

The microusb side is connected to target system (here is pc also), so you need to connect both sides to pc.
Do the same thing when uploading firmware.
by kaiba_seto2004
Sun Oct 07, 2018 10:21 pm
Forum: Support
Topic: HPP PRX Pedals and Accuforce Pro V2
Replies: 1
Views: 785

Re: HPP PRX Pedals and Accuforce Pro V2

Hello,

Just 1 gimx adapter, that is what you need :)
by kaiba_seto2004
Tue Oct 02, 2018 7:02 am
Forum: General Discussion
Topic: Accuforce Pro V2, HPP PRX pedals, and GIMX
Replies: 14
Views: 1540

Re: Accuforce Pro V2, HPP PRX pedals, and GIMX

Gimx can make your wheel become a Logitech G27 (not G29) for using on PC. Just upload firmware EMUG27PC and follow guide here:
by kaiba_seto2004
Sun Sep 30, 2018 2:30 am
Forum: Support
Topic: DIY GIMX Adapter doesn't show at COM3 anymore - Broken?
Replies: 9
Views: 300

Re: DIY GIMX Adapter doesn't show at COM3 anymore - Broken?

After you upload arduino board firmware, it won't show COM port in Device Manager anymore. So don't panic :) You can try this way to reupload firmware on it: - Connect both sides to PC. - Use Update firmware funtion in gimx-launcher. - When it says "Unplug/replug the USB cable from/to computer USB p...
by kaiba_seto2004
Sat Sep 29, 2018 5:32 pm
Forum: Support
Topic: DIY GIMX Adapter doesn't show at COM3 anymore - Broken?
Replies: 9
Views: 300

Re: DIY GIMX Adapter doesn't show at COM3 anymore - Broken?

When you plugged your USB to UART side to PC, nothing happen in Port right? So I think your USB to UART is dead. To make sure it is dead or not, try open Device Manager and look at Ports (COM & LPT) section. https://i.imgur.com/BySYEC7.png If you don't see the line USB to UART there, the answer is y...
by kaiba_seto2004
Sat Sep 22, 2018 4:49 am
Forum: Support
Topic: Analog movement using controller while aiming with mouse
Replies: 2
Views: 222

Re: Analog movement using controller while aiming with mouse

Of course you can.
Use gimx-config to bind analog from controller (you can use the same controller which was used to authenticate, no need another one) and bind mouse axis for aim.

P/s: you can refer config PS4_Battlefield1_Godlike.xml.