Game Input MultipleXer

No, I just reordered the same model from the same seller on ebay, which worked on my first project. Are there any drivers needed to detect the arduino ripoff? Is it possible that the flash went wrong even with a success message? What is the minimal effort to get to know if the hardware works properl...

Yes, but the joints look OK. Small and shiny. The same to the second arduino.

After my success with the Teensy I try to reach the same goal with cheaper components. I ordered two Arduino Leonardo Ripoffs and two CP2102. The firmware flash was successfull on both: avrdude -p atmega32u4 -c avr109 -P /dev/tty.usbmodemFA131 -D -U flash:w:atmega32u4.hex:i Connecting to programmer:...

Thank you for you answer. The problem did not occur for 2 hours. I'll have an eye on that and will alway start using --status.

The Rest of my config is described here: http://gimx.fr/forum/viewtopic.php?f=5&t=1512

Hello and thanks in advance for your (or our) time. My setup basically works, but using my G27 on Project Cars on a PS4, I cannot steer after a few minutes, I even can't press the PS Button on the DS4. I have to disconnect the cable to the DS4, gimx terminates on my shell, I have to reconnect the ca...

Sorry for being so impatient, after restarting the ps4 (that did run the whole time), all works fine. Thank you for your nice project.

Switched d2 and d3 now it looks better: ~/.gimx]$ gimx --config LogitechG27_G29.xml --port /dev/ttyUSB0 option -c with value `LogitechG27_G29.xml' option -p with value `/dev/ttyUSB0' native mode is already enabled for HID device 02:02 (PID=c29b) Detected USB adapter: G29 PS4. using default refresh p...