Difference between revisions of "Template:InstallationNext"
| Line 1: | Line 1: | ||
==Before Installation== | ==Before Installation== | ||
| − | {{#ifeq:{{{device|}}}|Steering Wheel | + | {{#ifeq:{{{device|}}}|Steering Wheel|===Install Logitech Gaming Software (LGS)=== |
| − | |===Install Logitech Gaming Software (LGS)=== | ||
Install the [http://www.logitech.com/pub/techsupport/joystick/lgs510.exe 32-bit LGS] on a 32-bit Windows, and the [http://www.logitech.com/pub/techsupport/joystick/lgs510_x64.exe 64-bit LGS] on a 64-bit Windows. | Install the [http://www.logitech.com/pub/techsupport/joystick/lgs510.exe 32-bit LGS] on a 32-bit Windows, and the [http://www.logitech.com/pub/techsupport/joystick/lgs510_x64.exe 64-bit LGS] on a 64-bit Windows. | ||
| Line 10: | Line 9: | ||
|}} | |}} | ||
| − | {{#ifeq:{{{platform|}}}|xboxone | + | {{#ifeq:{{{platform|}}}|xboxone|===Install the libusbk driver (Xbox One only)=== <!--T:8--> |
| − | |===Install the libusbk driver (Xbox One only)=== <!--T:8--> | ||
It is required to replace the stock controller driver with the libusbk driver. | It is required to replace the stock controller driver with the libusbk driver. | ||
Revision as of 17:57, 8 November 2017
Contents
Before Installation
Disable power saving for USB devices
This is required to prevent Windows from turning off the controller or the USB to UART adapter.
- Open the Device Manager.
- Right click on the USB HUB (make sure to select the right one) > Properties > Power management > Uncheck "Allow the computer to turn off this device to save power".
- Right click on the COM port > Properties > Power management > Uncheck "Allow the computer to turn off this device to save power".
System Preparation
- Install all Windows updates (otherwise USBDK may fail to work properly, resulting in GIMX failures)
- Create a system restore point, in case something goes wrong (USBDK was known to create instability on some systems)
Download and install the GIMX setup file
- 32-bit setup, for 32-bit Windows only
- 64-bit setup, for 64-bit Windows only
The setup file includes the following installers:
- CP210x driver - required when using a CP2102 USB to UART adapter
- USBDK driver - required when using a console that needs controller authentication
LibusbK can be used as an alternative to USBDK.
(not recommended)
- Rename the libusb-1.0.dll file from the C:\Program Files\GIMX folder to libusb-1.0.dll.bk.
- Download this libusb package: link.
- Open it (with 7zip for example) and extract the libusb-1.0.dll file from the /mingw64/bin/ folder to the C:\Program Files\GIMX folder.
- Install the libusbk driver as explained below.
Note: the libusb-1.0.dll file will be replaced after updating GIMX. Perform the above steps again to keep using libusbK.
