Page 1 of 1
Minimus AVR USB V1 connections!
Posted: Fri Apr 27, 2012 8:51 pm
by laytonanthony
Hey guys
Tried the USB bluetooth but getting lag. i have 2 minimus development boards i used for psgroove. the chip has an atmel AT90USB162 chip so should do the trick.
All i need is the pins for the Rx and TX and Gnd.
Does anybod no the pins for this?
Re: Minimus AVR USB V1 connections!
Posted: Fri Apr 27, 2012 9:01 pm
by laytonanthony
manage to find the pinouts for this board here.
these development boarda re only £4.00 cheap alternative
Re: Minimus AVR USB V1 connections!
Posted: Fri Apr 27, 2012 9:08 pm
by Matlo
Where did you bought them?
Re: Minimus AVR USB V1 connections!
Posted: Fri Apr 27, 2012 9:52 pm
by laytonanthony
Re: Minimus AVR USB V1 connections!
Posted: Sat Apr 28, 2012 11:44 am
by peshkohacka
.
Re: Minimus AVR USB V1 connections!
Posted: Sat Apr 28, 2012 3:00 pm
by laytonanthony
To confirm this MINMUS AVR USB V1 works fine. i have 2 of them and have used both to make leads.
The reason i used these was because i already had them for the old psgroove hack when it first came out. £4 does the trick if you ask me. also the usb to serial was £3 so a total spend of £7....not bad at all.