Page 2 of 2

Re: CronusMax+PS4+G27

Posted: Tue Jan 05, 2016 4:21 pm
by shaikhulud
Well, it's time to test this! =)
Anyway i've ordered spare cp2102 just in case. (CP2102 USB 2.0 to UART TTL 5PIN Connector Module Serial Converter with Dupont line from Ali)

Since my Arduino clone is still packaging, i think i'll recieve both converters ahead of it anyways and will test both of them with additional info, if needed.

Also i'm making Russian translation of the Wiki tutorials. Where should i send them?

Re: CronusMax+PS4+G27

Posted: Tue Jan 05, 2016 6:56 pm
by Matlo
The procedure is to create an account on the wiki, and to translate the pages following these instructions:
http://gimx.fr/wiki/index.php?title=Translate

Re: CronusMax+PS4+G27

Posted: Tue Jan 19, 2016 3:58 pm
by shaikhulud
option -l with value `log.txt'
option -c with value `LogitechG27_G29.xml'
option -p with value `COM5'
status flag is set
subpos flag is set
force_updates flag is set
native mode is already enabled for HID device \\?\hid#vid_046d&pid_c29b#7&2e46da46&0&0000#{4d1e55b2-f16f-11cf-88cb-001111000030} (PID=c29b)
Detected USB adapter: G29 PS4.
libusb_init: Entity not found.
No controller was found on USB buses.
adapter_detect failed

cp2102

my micro flashed correctly as i can see

UPD: Re-checked the wiring, tried to swap rx and tx, nothing. I blame TTL converter (cuz arduino flashed just fine)
Image

Re: CronusMax+PS4+G27

Posted: Tue Jan 19, 2016 6:59 pm
by Matlo
USBDK is required. Reinstall GIMX, and leave the "Install USBDK" checked.

Re: CronusMax+PS4+G27

Posted: Tue Jan 19, 2016 7:01 pm
by shaikhulud
Funny thing - i did. Can i somehow install it separately?

But i think maybe i've installed wrong exe. What's the difference between i386 and x86-x64 setup files?

Re: CronusMax+PS4+G27

Posted: Wed Jan 20, 2016 10:15 am
by Matlo
i386 is for Windows 32 bits and x86_64 is for Windows 64 bits.
The USBDK installer can be found in C:\Program Files\GIMX\tools.

Re: CronusMax+PS4+G27

Posted: Sat Jan 23, 2016 6:28 pm
by shaikhulud
Matlo wrote:I'm not sure the CH340 supports the baudrate used by GIMX (500kbps).
You know what? I think it's a hardware failure. Tried with clean Win 10 even after reinstalling USB DK - same shit. Ordered teensy 2.0 and another CP 2102 Baite (as you pictured), so i'll keep you posted.

Re: CronusMax+PS4+G27

Posted: Sun Feb 14, 2016 10:16 am
by shaikhulud
Updating my progress. Recieved Teensy 2.0, soldiered the pins, flashed it.

Works flawlessly even with my current cheap-ass 2102 converter.

Message to n00bs - never use Arduino or Arduino clones, Teensy is your 100% choice for GIMX.