Page 1 of 3
Simucube Augury G27 to pc
Posted: Sun Jun 16, 2019 9:30 am
by scritchs
Hello
I bought a Gimx at shop.
My config win10 a simucube augury with mige 20nm
Wheel is recognize in windows as Ardruino Micro in controller config
When i Try to play forza 7 with gimx i don't have any FFB
Here is the log of GIMX.
https://pastebin.com/6nbKNkQh
I used a clubsport v3 for pedals.
I used the emug27pc.hex firmware with g27ps3/pc type
Thanks a lot for your help
Re: Simucube Augury G27 to pc
Posted: Sun Jun 16, 2019 9:34 pm
by Matlo
Please generate a debug log file with 'controller' and 'haptic' flags checked.
Re: Simucube Augury G27 to pc
Posted: Mon Jun 17, 2019 9:15 am
by scritchs
Here is the log
https://pastebin.com/KdHmfE0p
thanks for your help
Re: Simucube Augury G27 to pc
Posted: Mon Jun 17, 2019 12:13 pm
by Matlo
I can see some FFB init sequence, but there are not FFB commands coming from the adapter after that.
Did you check in-game parameters?
Re: Simucube Augury G27 to pc
Posted: Mon Jun 17, 2019 4:33 pm
by scritchs
Yes all ffb is at 100%
I don't have any ffb in the wheel.
I didn't feel anything
Do i have to remap all entries in game?
Re: Simucube Augury G27 to pc
Posted: Tue Jun 18, 2019 5:50 am
by Matlo
Re: Simucube Augury G27 to pc
Posted: Tue Jun 18, 2019 6:39 am
by scritchs
Yes i install it
I follow gimx installation.
Re: Simucube Augury G27 to pc
Posted: Tue Jun 18, 2019 7:22 am
by Matlo
Did you check if the FFB is enabled in the LGS? Did you test the FFB from the LGS?
Re: Simucube Augury G27 to pc
Posted: Tue Jun 18, 2019 7:55 am
by scritchs
I can't test ffb in logitech profiler there's nothing to do that. but all settings is at 100% . And i see that wheel turn ok.
here is the message i see when i turn on gimx
https://ibb.co/b2Lh5W6
Re: Simucube Augury G27 to pc
Posted: Tue Jun 18, 2019 8:06 am
by scritchs
Ok i have a ffb but i was very very insignifiant. When i slide a lot with a car i feel a little ffb. How could i change that ?