I just built my GIMX adapter today based on arduino micro pro and an CP2102. Uploaded firmware and until there everything went fine.
I am using a laptop under windows 10 and a Xbox One X, mouse is a Razer Orochi 2013.
I downloaded a game configuration for apex legends, adapted my DPI to 6400. I then ran the "curses" tool to adapt my configuration.
While the keyboard part works fine, I never got the mouse to have a decent respond, going slowly, it's decent, but if I move at normal speed, it has a lot of jitter. I then tried with HALO 5 and have the same problem.
I then thought well, maybe the Orochi actually doesn't go to 6400DPI without the Razer tool, so I installed Razer Synapse and I now get a BSOD each time I start GIMX capture, KMODE_EXCEPTION_NOT_HANDLED. WhoCrashed gives me this :
Code: Select all
On Tue 14/05/2019 21:21:19 your computer crashed or a problem was reported
crash dump file: C:\WINDOWS\Minidump\051419-12562-01.dmp
This was probably caused by the following module: ntoskrnl.exe (nt+0x1AA0A0)
Bugcheck code: 0x1E (0xFFFFFFFFC0000005, 0xFFFFF801C8F606F1, 0x0, 0x18)
Error: KMODE_EXCEPTION_NOT_HANDLED
file path: C:\WINDOWS\system32\ntoskrnl.exe
product: Microsoft® Windows® Operating System
company: Microsoft Corporation
description: NT Kernel & System
Bug check description: This indicates that a kernel-mode program generated an exception which the error handler did not catch.
This might be a case of memory corruption. This may be because of a hardware issue such as faulty RAM, overheating (thermal issue) or because of a buggy driver.
The crash took place in the Windows kernel. Possibly this problem is caused by another driver that cannot be identified at this time.
I can't get GIMX to work anymore... Anyone had similar problem? Is there a fix?